Forums

kbsserv

Hi

Just got back from weekend in malvern,prob is the hymer sits nose down
normally,shower at front,waste tank at back,so unless we level the van,the water will not drain.Got some Fiamma levelling blocks but they are not high enough.Does anyone know of any blocks which are higher,could do with about 200mm lift.

Regards
Karl

ksebruce

We use two sets of blocks one on top of the other as required.

Grizzly

Take a couple of short planks of wood of the right thickness and put those under the levelling ramps.

G

Rapide561

Hello

A scaffolding plank is ideal when cut into shorter pieces. Chat nicely to a builder etc

Russell

peejay

Hi;

Afaik the highest leveling blocks you can get are called

ivys

On a few occasions those 13cm blocks have not been high enough. I am planning to make some base units for the 13cm wedges to sit in. I think I need another 4-5cm.

The problem with loose planks is that they're unstable. That's why I want to make some for the Fiamma chocks to fit in.

Roger

homerdog

Living in Malvern, the easiest thing to do would have been to drive a bit further up the hills and get a better incline, i.e. 1:4. Just a thought!! H

chapter

if its only a slight fall why not turn the van around and ramp the the other end so the water can run to the tank and if the pitch is to steep park sideways on or ask for a pitch thats not designed for a caravan with wind down jacks i never take a pitch if i'm not happy with it

kbsserv

Thanks for the various replies,I think using some sort of ply base may be
the best solution,But how do you use two together,put them on top of each other??

regards
Karl

kbsserv

Hi

Well sorted problem with levelling,made a frame for fiamma blocks

thought other members who are suffering with blocks not high enough might be interested,so posted a couple of pics.

I have built a frame for the existing blocks,thought the best way to do it.

And it works really well.

Regards
Karl