Forums

jimthefish

Calling all Nuevo owners. Going to fit a reversing camera on the sloping bodywork under the brake light over the rear window.
Been told by Autosleeper that this light is glued in and had to be broken to take it out. This means I have to drill a 28mm hole without knowing what is below this light.
any advice would be welcome, even don't do it advice.

Jim the fish Confused

EOR

I've posted you a reply in the tec. section Very Happy

Milemuncher

Could AS not do the job for you. I know it will be more expensive than doing it yourself BUT it will be done right. I would rather pay than make a very expensive mistake.
Have you looked on the ASOC website for their technical datasheets. don't know if there is one but doesn't cost to look.
Good luck perhaps you could take photos to document the operation.

fjmike

Why drill holes in your motorhome if you have somewhere you can mount the camera , you can then feed the wire through plastic conduit , stick the conduit to the van , then feed the cable underneath to the cab. I did this with my Dethleff (photo in my photo album)