Motorhome Facts Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
Whilst replacing a cross member and a few other bits on my van I jacked up a corner but misplaced the jack. :oops: It has scratched off some black "stuff" :( . Looks and feels paperlike. I assume it has been put on to stop rust. What should I do to fix/stop any future corrosion? I think the paint is OK underneath but there is a little rust around the hole at the jack point.
 

·
Registered
Joined
·
753 Posts
Underbody seal or schultz. Grab a can from the nearest car accessory store, don't forget though, if it is an aerosol to heat in warm water first to stop it blocking the nozzle!

Should cost around £5 a can - if you don't fancy that, blob some dirty engine oil over as a temp fix.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top