Motorhome Facts Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
41 Posts
Discussion Starter · #1 ·
Calling all Nuevo owners. Going to fit a reversing camera on the sloping bodywork under the brake light over the rear window.
Been told by Autosleeper that this light is glued in and had to be broken to take it out. This means I have to drill a 28mm hole without knowing what is below this light.
any advice would be welcome, even don't do it advice.

Jim the fish :?
 

·
Registered
Joined
·
66 Posts
Could AS not do the job for you. I know it will be more expensive than doing it yourself BUT it will be done right. I would rather pay than make a very expensive mistake.
Have you looked on the ASOC website for their technical datasheets. don't know if there is one but doesn't cost to look.
Good luck perhaps you could take photos to document the operation.
 

·
Registered
Joined
·
355 Posts
Why drill holes in your motorhome if you have somewhere you can mount the camera , you can then feed the wire through plastic conduit , stick the conduit to the van , then feed the cable underneath to the cab. I did this with my Dethleff (photo in my photo album)
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top