Motorhome Facts Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,136 Posts
Discussion Starter · #1 ·
Yesterday I changed the LNB for a better one and then put the dish down, after a few minutes I decided to try it again but the dish would not go up. The first error message was "switch on receiver", the Sky box was however on and to make sure that this was not faulty I tried another box and still got the same reading. I decided to remove the power from it and try again, this time the error message was "initialising X motor". The dish moved around on a horizontal plane until it met up with the rooflight which caused it to stop.
Now it appears to be stuck and will not even move back to it's starting position. No controls will work with the error message being displayed all the time.
I've left a message for Shane ( Snellyvision) to give me a call but I wondered if anyone had any ideas.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top