Motorhome Facts Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
We have a 2006 Murvi Morelo in which we have started to receive a 'Selection not available' message when pressing the buttons on the VB03 control panel.
I thought the leisure batteries may be too low so hooked up to mains for a few days but the message is still there.
The only buttons that work are the 'All lighting button' (top righ when pressed for more than a second, and the inside/outside temp reading.
The leisure batteries are reading around 14v to they seem fine.
I've shut the unit down and restarted and the problem is still the same.

Any suggestions?
thanks
Steve

Font Auto part Gas Display device Electronic device
 

· Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thank you for your response.
I've pulled the main vehicle fuse and left it, plug it back in, restarted the system and still the same.
I have also posted on a Murvi forum and the suggestion is corrosion on the cables going into the control boxes so I will work on that and report back.
Thanks again for your help
Steve
 
1 - 2 of 2 Posts
Top